Turn your Raspberry Pi® into a drone controller
Navio2 eliminates the need in multiple controllers onboard making development easier and increasing robustness.
What's on board
- GNSS receiver - Tracks GPS, GLONASS, Beidou, Galileo and SBAS satellites. External antenna with MCX connector
- Dual IMU - Accelerometers, gyroscopes and magnetometers for orientation and motion sensing
- RC I/O co-processor - Accepts PPM/SBUS input and provides 14 PWM output channels for motors and servos
- High resolution barometer - Senses altitude with 10 cm resolution
- Extension ports - Exposed ADC, I2C and UART interfaces for sensors and radios
- Triple redundant power supply - With overvoltage protection and power module port for voltage and current sensing
Specifications
Mechanical
- Size: 55 x 65 mm
- Weight: 23 g
- Operating tº: -40…+85ºC
Electrical
- Supply voltage: 4.75-5.25V
- Power supply: Power module, servo rail, USB
- Average current consumption: <150mA
Ports
- Power module
- UART
- I2C
- ADC
- 12 PWM servo outputs
- PPM/S.Bus input
ICs
- MPU9250 9DOF IMU
- LSM9DS1 9DOF IMU
- MS5611 barometer
- U-blox M8N GLONASS/GPS/Beidou (antenna connector type MCX)
- Cortex-M3 RC I/O co-processor
- RGB LED
Kit contains:
- Navio2 board
- GPS/GLO antenna for Navio2
- Power module for Navio2
- Wire pack for Navio2
Note: Raspberry Pi not included